Jump to content
  • Announcements

    • Rahul Ponginan

      Please click here for a short but important announcement   03/26/17

      Dear Users Our Commercial and Academic users around the world can use these same forums here as before i.e. the Altair Support Forum , Commercial users from India with solver queries can go to the Solver Forum for India Commercial Users , Academic Users from India and AOC India Participants are requested to go to the Forum for India Academic Users and AOC India Participants , We will be tending to all queries in all the forums promptly as before, thank you for your understanding. 
  • 0

meshing error


Hi Im getting a error code when i run my topology. The error code is 'ERRORS DURING ELEMENT QUALITY CHECK' is there any way i can by pass this error. I am running a simulation with 2d surface mesh as non-design area and 3d internal as design area. any solutions guys?

Share this post

Link to post
Share on other sites

1 answer to this question

Recommended Posts

  • 0



You can by-pass Element quality check, but even in that case it should have reasonable mesh quality  -

Analysis > Control Cards  > PARAM > CHECK > ELEM

Image 7.jpg


For further  error, you can share your model file to me by through drop-box will look into that to solve your issue.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now