Jump to content

mertcgunay

Members
  • Content count

    8
  • Joined

  • Last visited

About mertcgunay

  • Rank
    Newbie

Profile Information

  • Country
    Turkey
  • Are you University user?
    No

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. mertcgunay

    Using MATT1 with PCOMP Property

    Hi, I am trying to do an analysis on a enamelled sheet metal part, it is bimaterial. As initial condition, temperature is 350 celcius degrees and as final condition, temperature is 25 celcius degrees. So, I applied a temperature load. I used MATT1 and entered temperature dependent material properties in TABLEM1 format. I used PCOMP card to model the structure as composite. Materials (Steel and Enamel) are taken as isotropic materials so there is no ply orientation. When I start the analysis with Optistruct, the programme gives the following error message: ERROR 14: Missing property # 2 referenced by CQUAD4 # 1 What can I do to solve this problem? Thanks in advance. Mert
  2. mertcgunay

    Segmentation Error During Trimming Operation

    I tried to hide the elements out of interest and it didn't helped.
  3. mertcgunay

    Segmentation Error During Trimming Operation

    Prakash, thanks for your reply. I erased the setting files as you pointed but the problem continues. We did same procedure in another computer but the segmentation error problem continues.
  4. Hi, I am doing a trimming operation on a part. After the forming operation, I used the .sta file and started to do the trimming process. I did much of the trimming but at the last step, I wanted to trim the part with the sloth shaped lines. Everytime I do the operation, Hyperform crashes with a segmentation error. I cleaned the temp file and restarted the computer but the problem didn't finished. Can anyone help we with this problem? You can see the sloth shaped trimming lines from photo below. Thank you in advance. Mert Cevdet Günay
  5. mertcgunay

    Linear Static Analysis with Thermal Boundary Conditions

    Hi, I want to make a correction. The problem I am defining above should be solved by Nonlinear Transient Analysis methods. Regards. Mert Cevdet Günay
  6. mertcgunay

    Linear Static Analysis with Thermal Boundary Conditions

    Prakash, thanks for your reply. I am actually trying to solve the problem not as a heat transfer but as a linear static analysis with temperature as the only variable. I want to define the cooling regimen as Temperature-Time graph and see the response of the bimaterial structure. Thanks Mert Cevdet Gunay
  7. Hello, I am working on a project to simulate the cooling phase in an enamelling process. I simply generated a composite cantilever beam with two different materials to obtain the stresses and displacements during cooling process. I will cool down the composite cantilever beam from an elevated temperature to room temperature. The problem is, I am new to thermal boundary conditions and I can't find the correct load collector combination to handle the problem. To summarize the simulation; 1. Structure is at 350 degrees celcius and it will cool down to 20 degrees celcius. 2. Due to thermal expansion coefficent difference, the composite beam will deform. Thanks in advance! Mert Cevdet Gunay
  8. mertcgunay

    Error percentage in forming analysis

    Hello, I am doing forming analysis of a sheet metal part. I modelled the process with Hyperform and solved it with Radioss. The simulation converged and gave me a result. The error percentage made me suspicious about the result. The error is 24.8%. Do you have any suggestions or any error range to make me rely on my results?
×