Jump to content
  • Announcements

    • Rahul Ponginan

      Please click here for a short but important announcement   03/26/17

      Dear Users Our Commercial and Academic users around the world can use these same forums here as before i.e. the Altair Support Forum , Commercial users from India with solver queries can go to the Solver Forum for India Commercial Users , Academic Users from India and AOC India Participants are requested to go to the Forum for India Academic Users and AOC India Participants , We will be tending to all queries in all the forums promptly as before, thank you for your understanding. 
  • 0
Balaji Viswanadh G

Reposting in India Forum: Difference in Heat maps between time variant and identical non time variant results


in my analysis I observed that, Time variant and non-time variant simulation results are not exactly identical (as we would usually expect) in the entire prediction area. I see sharp contrasts especially towards the edges of prediction area. I tried to view the prediction in 3D, however time variant 3D view is responding very very slow.

I tried to export results and compare, however the time variant ASCII file is very huge (~700-800MB). It could be because time variant model Is exporting data for all time instances which I don't need. Please advise if there is a way I can extract data only for single time instant? Also, please advise if I can 3D view the time variant simulation result without hanging my ProMan.

Please advise




Share this post

Link to post
Share on other sites

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now