Jump to content
  • Announcements

    • Rahul Ponginan

      Please click here for a short but important announcement   03/26/17

      Dear Users Our Commercial and Academic users around the world can use these same forums here as before i.e. the Altair Support Forum , Commercial users from India with solver queries can go to the Solver Forum for India Commercial Users , Academic Users from India and AOC India Participants are requested to go to the Forum for India Academic Users and AOC India Participants , We will be tending to all queries in all the forums promptly as before, thank you for your understanding. 
riham1994

Wrong strain value

Recommended Posts

Hi, 

 

i defined stress-strain curve  using TABLES1 card and MATS1 cards and prepared my model to be calculated in optistruct. The problem is that while i'm checked the stress-strain variation in hyperview it shows a 0.003 strain for 742MPa value of stress for the same element and it's little bit weird. the stress-strain variation is as shown below, so for this stress the variation of strain should be between 0.05 and 0.07!! i want to see the plastic strain for this plastic constraint could anyone help !!

 

 

 

 

Capture1.PNG

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×