Jump to content
  • Announcements

    • Rahul Ponginan

      Please click here for a short but important announcement   03/26/17

      Dear Users Our Commercial and Academic users around the world can use these same forums here as before i.e. the Altair Support Forum , Commercial users from India with solver queries can go to the Solver Forum for India Commercial Users , Academic Users from India and AOC India Participants are requested to go to the Forum for India Academic Users and AOC India Participants , We will be tending to all queries in all the forums promptly as before, thank you for your understanding. 
  • 0
Sign in to follow this  
Sra

Network Schematic and 3D model in FEKO

Question

Sra    0

Hello,

 

I modeled a PIFA antenna in FEKO. I excited the antenna with wire port. Till here everything is clear.  I would like to inherit the properties of a PEC solid cable into simulation. For this I opened a network schematic and in the network schematic, I connected the wire port to port 1 of transmission line with specific properties and port 2 of transmission line is connected to a voltage source. So my question is how can I simulate this model. I normally simulated the antenna model but am not sure what FEKO is doing with the network schematic. Any comments please.

Share this post


Link to post
Share on other sites

1 answer to this question

Recommended Posts

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×