Jump to content
  • Announcements

    • Rahul Ponginan

      Please click here for a short but important announcement   03/26/17

      Dear Users Our Commercial and Academic users around the world can use these same forums here as before i.e. the Altair Support Forum , Commercial users from India with solver queries can go to the Solver Forum for India Commercial Users , Academic Users from India and AOC India Participants are requested to go to the Forum for India Academic Users and AOC India Participants , We will be tending to all queries in all the forums promptly as before, thank you for your understanding. 
  • 0
vikas kenchapur

Continous Sliding Contact Analysis of a Buckle using OptiStruct

Question

1 answer to this question

Recommended Posts

  • 0

I tried prepare similar model, setup was exactly the same but after first contact, snap-fit started deform, this is OK, but snap-fit continue in deformation instead of copy shape of surface as in video above. Does someone have idea, what I do bad ?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×