Jump to content
  • Announcements

    • Rahul Ponginan

      Please click here for a short but important announcement   03/26/17

      Dear Users Our Commercial and Academic users around the world can use these same forums here as before i.e. the Altair Support Forum , Commercial users from India with solver queries can go to the Solver Forum for India Commercial Users , Academic Users from India and AOC India Participants are requested to go to the Forum for India Academic Users and AOC India Participants , We will be tending to all queries in all the forums promptly as before, thank you for your understanding. 

Search the Community

Showing results for tags 'auto'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Altair Support Forum
    • Welcome to Altair Support Forum
    • Installation and Licensing
    • Modeling (Preprocessing)
    • Analysis (Solvers)
    • Optimization and Design Exploration
    • Visualization (Postprocessing)
    • Model Based Development
    • Conceptual design and Industrial design
    • Manufacturing Simulation
    • CAE Process Automation
  • Academic Partner Alliance Forum
    • APA - Composites
    • APA - CFD & Thermal
    • APA - Vehicle Dynamics
    • APA - Manufacturing
    • APA - Crash and Safety
    • APA - Noise, Vibration and Harshness
    • APA - System Level Design
    • APA - Structural and Fatigue
  • Forum for India Academic Users and AOC India Participants
    • India EDU Installation FAQ
    • India EDU Modeling and Visualisation
    • India EDU Linear, Non-Linear Solver ( Implicit/Explicit)
    • India EDU Multi-Body Dynamics
    • India EDU CFD
    • India EDU Optimisation
    • India EDU Report Generation
  • Solver Forum for India Commercial Users
    • IND - OptiStruct for Linear & Non-Linear Implicit
    • IND - OptiStruct & HyperStudy for Optimisation
    • IND - RADIOSS for Impact Safety & Non-Linear Explicit Applications
    • IND - MotionSolve for Multi-Body Dynamics
    • IND - HyperWorks CFD forum
    • IND - FEKO, Winprop & Flux
  • Forum for our Australia and New Zealand Based Users
    • ANZ - HyperWorks
    • ANZ - Electromagnetics
    • ANZ - HPC (PBS)

Categories

There are no results to display.


Found 2 results

  1. My question is how to use TCL scripts to swap master-slave surface. Like the figure attached, I want to swap master-slave surface of those highlighted contact pairs. I want to use Young's modulus to decide which surface should be master, and the other to be slave. Master surface should have higher Young's modulus. So, how can I write this if statement and swap the master-slave surface? My model is also uploaded, and I have created the contact pairs. But the contact pairs have'nt been swapped. raw.hm
  2. Hi everyone, I have problem obtaining the TCL command of auto contact pair finding. My model contains 6 components, I use the Abaqus contact manager to automatically find contact pairs for me. Manually, I can successfully find contact pairs. Since I want to run this process automatically by TCL script, I do the process manually and check out the code added in the command.cmf file. Unfortunately, the code are very long, approximately 50000 lines. Also, the code are about nodes' data and surface set, which is not I am looking for. I am looking for the command that represents the buttons "auto", "components: all", "find", "create". I will show these buttons in the figures attached. By the way, the file: raw.hm is my model. Again, my goal is to get the TCL code for finding contact pairs. Please help me, thanks! raw.hm
×