• Announcements

    • Rahul Ponginan

      Please click here for a short but important announcement   03/26/17

      Dear Users Our Commercial and Academic users around the world can use these same forums here as before i.e. the Altair Support Forum , Commercial users from India with solver queries can go to the Solver Forum for India Commercial Users , Academic Users from India and AOC India Participants are requested to go to the Forum for India Academic Users and AOC India Participants , We will be tending to all queries in all the forums promptly as before, thank you for your understanding. 

riham1994

Members
  • Content count

    47
  • Joined

  • Last visited

About riham1994

Profile Information

  • Country
    Morocco
  • Are you University user?
    Yes

Recent Profile Visitors

91 profile views
  1. i don't have motionsolve v13.0 and 14.0
  2. hii, i guess this doesn't work, i checked the log file and the plastic strain is zero for the very first iterations ps: the running isn't completed yet
  3. honestly this is my first use of hypermesh for this type of analysis, could you be much more clear and explain it step by step
  4. i'm using static analysis, could you develop what load increments means! i've seen a post of Rahul Ponginan saying that in non linear static analysis load shoould be applied in increments how can i do this please
  5. Hi, i defined stress-strain curve using TABLES1 card and MATS1 cards and prepared my model to be calculated in optistruct. The problem is that while i'm checked the stress-strain variation in hyperview it shows a 0.003 strain for 742MPa value of stress for the same element and it's little bit weird. the stress-strain variation is as shown below, so for this stress the variation of strain should be between 0.05 and 0.07!! i want to see the plastic strain for this plastic constraint could anyone help !!
  6. Hi, i defined stress-strain curve using TABLES1 card and MATS1 cards and prepared my model to be calculated in optistruct. The problem is that while i'm checked the stress-strain variation in hyperview it shows a 0.003 strain for 742MPa value of stress for the same element and it's little bit weird. the stress-strain variation is as shown below, so for this stress the variation of strain should be between 0.05 and 0.07!! i want to see the plastic strain for this plastic constraint could anyone help !!
  7. hii Prakash, Could you answer me please
  8. it only works in a braking analysis, i want to perform cornering analysis, J turn analysis, accel analysis and other. And also to change parameters of braking analysis such as deceleration. How can i do it?
  9. it's finally working.. i created a fake folder v14.0 with the same location. i will update to you soon if the model have no problem with braking analysis. Ps: Thank you soo much for helping me
  10. Same problem i think it's a matter of the version 12.0 i'm using !!
  11. hi Prakash, I can't have the log file because i can't perform straight line braking analysis due to export model failure as shown below.
  12. the model doesn't work it says that there is an export fail !
  13. it's attempting for MKEM here's the log file static ride.log
  14. I didn't found among options the tolerance !! from where i can change it ?
  15. i used template model in this case to make sure that the problem comes from the flex body and yes i have the same problem